BODY 1-12
Fig. 30— Rear Door Installation - Panel and Suburban
be made after the door is positioned in the opening.
4. Position striker assembly on body lock pillar so the
rotor cover outer face on the door swings into the
striker assembly with .10 inch clearance to the lock
rotor cover. Use special burred shims as required.
Under usual conditions, shims are not
NOTE:
required.
5. As an aid to striker adjustment outline the striker in
pencil or crayon for use as a base for adjustment.
Horizontal slots are provided in the striker plate to
position the striker assembly laterally so that the
door outer surface is flush with the pillar surface at
the door rear edge within 1/16". Refer to Figure 45.
The striker inner edge must be parallel to
NOTE:
the striker mounting depression on the pillar.
Fig. 3 1 — Vent Assembly Inner Door Panel Attachment
Fig. 32— Ventilator Assembly Removal
DOOR VENTILATOR ASSEMBLY
Removal
The channel between the door window
NOTE:
glass and door vent is removed as part of the
vent assembly.
1. Regulate the door window glass to the full down
position.
2. Remove one clip each from the door lock handle.
3. Remove four (4) trim panel screws and trim panel.
4. Remove screws shown in Figure 31,
5. Slide
door
window
ventilation.
6. Remove three sheet metal screws at the upper front
of the door (fig. 32).
7. Turn the vent assembly 90° and carefully remove by
guiding up and out (fig. 32).
Installation
Replace the door window glass and
NOTE:
regulate to the full down position before install
ing the door ventilator assembly.
Fig. 3 3 — Adjusting Ventilator Operating tension
glass
rearward
away from
10-30 CHEVROLET TRUCK SERVICE MANUAL