Hinge Adjustm Ent; Step Assembly-Side Door - Chevrolet 30 Series 1967 Service Manual

Fig. 57 - W ind o w Regulator Roller and G u id e Rail
pins. Make certain the stop is positioned the same as
when first installed.
Hinge Adjustment (Fig. 63)
Side cargo, rear and front side door hinge adjustments
are made in a sim ilar manner as other truck doors.
STEP ASSEMBLY—SIDE DOOR
The Sport Van step assembly is actuated by the for­
ward side load door. The step may be kept inoperative
by pulling the pin linking the actuating rod to the door.
Proper adjustment of the door-step results in a slight
effort at the door closing.
Fig. 58 - Front Side Door W ind o w Replacement
Fig. 59 - Rear Door Lock, Rod Assembly and Inside Handle
Removal (Fig. 64)
1. Fully open forward side door—extending step as­
sembly.
2. Pull pin securing rod end to door and tape rod end
to rod for reinstallation.
3. Remove 4 screws securing rod cover to floor.
4. Remove cotter pin, washer and spring from rod.
5. Remove 7 bolts securing step assembly to Van floor.
. From underside remove 2 screws, washers and nuts
6
attaching step assembly to rocker.
7. Remove 2 inboard bolts from underside.
. Standing outboard of step assembly pull step down
8
and out for removal.
Installation
1. Raise vehicle.
2. Balancing step assembly by pivot rod, start 2 inboard
bolts. Fasten 2 screws, washers and nuts to rocker.
3. Lower vehicle and install 7 bolts in Van floor.
Fig. 60 - Forward Side Load Door - Sport Van
BODY IB-25
CHEVROLET TRUCK SERVICE MANUAL