High Beam Headlight Adjustment; Cleaning Your Atv; Waring - Linhai LH500ATV-D Owner's/Operator's Manual

16. MAINTENANCE

High beam Headlight Adjustment

The High beam headlight can be adjusted up and down.
1. Place the vehicle on a level surface with the headlight approximately
10''(3m) from a wall.
2. Measure the distance from the floor
to the center of the headlight and
make a mark on the wall at the same
height.
3. Start the engine
headlight switch to high beam.
4. Observe headlight aim. The most
intense part of the headlight beam
should be aimed 2.8'' (71mm) below
the mark placed on the wall in step 2. NOTE : Riding weight must be
included on the seat.
5. To turn the two adjusting bolt ① clockwise is to heighten the beam area
and to turn the two adjusting bolt ① counterclockwise is to lower the beam
area.
The dipper headlight adjustment is the same to the High beam Headlight.

Cleaning Your ATV

Keeping your ATV clean will extend the life of various components.
Washing
Never use a high pressure type car wash system, it can damage to the wheel
bearings, transmission seals, body panels, brakes and warning labels, and
water might enter the engine or exhaust system.
The best and safest way to clean your ATV is with a garden hose and a pail of
mild soap and water. Use a professional type washing mitten, cleaning the
upper body first and lower parts last. Rinse with water frequently and dry with a
chamois to prevent water spots. NOTE: If warning labels are damaged,
contact your dealer for replacement.

Waring

Your ATV can be waxed with any non-abrasive automotive paste wax. Avoid
the use of harsh cleaners since they can scratch the body finish.
LH500ATV-D
and turn the
OWNER'S/OPERATOR'S MANUAL
14.0
16-24