Handlebar Adjustment; Wheel Nut Torque Specifications - Linhai LH500ATV-D Owner's/Operator's Manual

16. MAINTENANCE
WARNING
Improper adjustment of the handlebars or incorrect torque of the adjuster block
tightening bolts can cause limited steering or loosening of the handlebars,
resulting in loss of control and possible serious personal injury or death.

Handlebar Adjustment

Your ATV has handlebars
which can be adjusted for
your personal fit.
1. Remove the handlebar cover.
2. Loosen the four bolts.
3. Adjust handlebar to desired
height. Be sure handlebars do
not hit gas tank or any other part
of machine when turned fully to left or right.
4. Torque handlebar adjuster block to 10-12 ft.Ibs(14-16Nm).
NOTE: Tighten bolts so there is an equal gap at the front and rear of the
handlebar block. Improper gap will result in improper fit of upper pod.
The following items should be checked occasionally for tightness; or if they
have been loosened for maintenance service.
Wheel Nut Torque Specifications（On Independent Suspension model ）
Bolt Size
Front （ALUMINIUM
WHEEL） M12X1.25
Rear （ALUMINIUM
WHEEL） M12X1.25
NOTE: All nuts that have a cotter pin installed must be serviced by an
OWNER'S/OPERATOR'S MANUAL
LH500ATV-D
Specification
69Ft.Lbs
69Ft.Lbs
95N.m
95N.m
14.0
16-11