Vehcle Break-In Period - Linhai LH500ATV-D Owner's/Operator's Manual

9. VEHCLE BREAK-IN PERIOD

The break-in period for your new ATV is defined as the first 50 hours of
operation. No single action on your part is as important as a proper break in
period. Careful treatment of new engine will result in more efficient
performance and longer life for the engine. Perform the following procedures
carefully.
CAUTION
do not operate at full throttle or high speeds for extended periods during the
break-in period. Excessive heat can build up and cause damage to close fitted
engine parts.
Please set a limit to
half throttle during
the break-in periods.
1. Locknut 2.Adjuster
1. Fill fuel tank.
2. Check oil reservoir level indicated on dipstick. Add oil if necessary.
3. Drive slowly at first. Select an area which is open and will give you room to
familiarize yourself with vehicle operation and handling.
4. Vary the throttle positions. Do not operate at sustained idle.
5. Perform regular checks on fluid levels, controls and all important areas on
the vehicle as outlined earlier on the daily pre-ride inspection checklist
found in"4.daily pre-ride inspection".
6. Don't pull loads.
7. Break in oil and filter. Change at 20 hours or 500 miles/800km.
OWNER'S/OPERATOR'S MANUAL
LH500ATV-D 14.0
9-1