Bosch Rexroth IndraControl VDP 16.1 Project Planning Manual page 35

DOK-SUPPL*-VDP16/40/60-PR03-EN-P
Rexroth IndraControl VDP 16.1/40.1/60.1 Operator Display
DANGER
The mounting surface of the operator display must be:
● free of impurities and
● has to be provided with sufficient mechanical strength and flatness
These criteria influence the required degree of protection IP to a great extent.
Further required measures are to be taken depending on the mounting location,
e. g. the stabilization of the mounting frame.
1. Create a mounting cut-out with 8 holes and a diameter of 5 mm according
to the illustrations "Mounting dimensions" on the following pages.
2. Remove the paper strip from the seal on the rear side of the front panel.
3. Insert the display from the front into the cut-out. The mounting bolts M4
are inserted into the drilled holes.
4. Fasten the display by screwing the nuts at the rear side of the mounting
bolts.
NOTICE
Screwas are to be fastened with the respective mounting torques specified in
the following table.
Threads
M2.5
M3
M4
M5
Fig.5-16: Mounting torques
Bosch Rexroth AG
Dimensions and Installation
Loss of degree of protection IP 65!
Damage of the mechanics caused by wrong
mounting torque.
Mounting torques
0.4 Nm
0.7 Nm
1.4 Nm
2.8 Nm
33/69