Braun VitalScan 1 Manual page 9

4
4. Press power button
measurement is in progress, do not move or speak.
Note: If necessary to interrupt a measurement, press the
immediately cancels the measurement, lowers cuff pressure and enters sleep mode.
5. The cuff will first inflate and then deflate. At the end of the measurement a final
beep sounds and the reading is displayed:
Upper (systolic) value
Lower (diastolic) value
Pulse
6. Press the power button
turn off automatically after 1 minute. If at any time, you want to stop the
measurement, press the power button
7. Tests results will be saved into the memories automatically ( see Average &
memory functions below). If you don't want store the data, press and hold the
power button
button to confirm operation.
Irregular heartbeat detection (only for VitalScan 3)
This symbol indicates that certain pulse irregularities were
detected during the measurement. In this case, the result may
deviate from your normal basal blood pressure – repeat the
measurement. In most cases, this is no cause for concern. However,
if the symbol appears on a regular basis (e.g. several times a week
with measurements taken daily), we advise you to tell your doctor.
CAUTION:
requiring medical attention. We recommend contacting your physician
if you see this icon frequently.
5
to begin. The measurement starts automatically. While
to turn the product off. Otherwise the product will
5 seconds until the M icon is flashing, then press the memory
An irregular heartbeat can be a serious medical condition
6
at any time. The device
.
7