Setting Of The Interfaces; With The Terminal Program "Hyper-Terminal - Siemens 7XV5550-0xA00 Series Manual

6.3

Setting of the interfaces

6.3.1

With the terminal program "Hyper-Terminal"

The terminal program ´Hyper-Terminal´ is delivered for all WINDOWS
9x and WINDOWS
Start / Programs / Accessories / Communications / Hyper Terminal
After starting the program choose the serial PC-interface e.g. COM1 or
COM2 and select under it´s Properties the baudrate with 9600 Baud/s
and the data format with 8N1. Also the hardware handshake is
supported by the RS232 interface in this setting mode. Store this values.
Note! Any changes are stored only
after a disconnection and renewing
of the connection.
If the DIP-switch S2.1 is in "ON"
position, after energizing the Active
Mini-Starcoupler the following text
appears in the terminal window. The
setting mode is active now.
14.01.2002
®
NT4 operational system software.
Active Mini-Starcoupler
®
Page 33 from 52