Connecting Wlan Antennas - Siemens RUGGEDCOM RX1400 Installation Manual

Installing the Device
2.5.5 Connecting WLAN Antennas
2.
3.
2.5.5

Connecting WLAN Antennas

Install a single WLAN antenna for Single-Input Single-Output (SISO) or dual antennas
for Multiple-Input Multiple-Output (MIMO).
To install a WLAN antenna, do the following:
1.
2.
20
If required, connect the optional lightning arrestor, line amplifier or bandpass fil-
ter to the antenna.
2
1
Drain Wire
1
RUGGEDCOM RX1400
2
Shielded Coaxial Cable
3
Lightning Protector, Line Amplifier or Bandpass Filter
4
Ground Wire
5
GPS Antenna
6
Figure 2.7 Antenna and Lightning Protector Assembly (Optional)
Using shielded coaxial cables, connect the antenna assembly to the ANT2 port
on the device.
Select an appropriate antenna. For a list of available WLAN antennas, refer to
"Available Antennas (Page
Mount the antenna to a pole or wall in an area that provides good signal cover-
age and is away from any signal noise emanating from other communications
equipment.
3 4 3 5 5
1
14)".
6
RUGGEDCOM RX1400
Installation Manual, 09/2019, C79000-G8976-1103-13