Year Limited Warranty - Sunbeam SB1800 Operating Instructions Manual

Needle shank not seated in
the upper end
Thread
keeps
Thread tension dial, thread
breaking
guide or thread pulling bar
rough
Upper thread is too loose or
incorrectly threaded
Stitches too
loose or
uneven
Upper thread is too tight or
lower thread too loose
Needle bent or deformed
Presser foot too loose
Needle
breaks Pulling fabric with force while
sewing
Needle not lowered into fabric
when starting to sew
The SB1800 / SB1818 Compact Sewing Machine is warranted for 1 year from provable date of purchase against defects in
During this period such defects will be repaired, or the product will be replaced without charge.
This warranty does not cover damage caused by misuse, negligence or improper installation. Warranty is also invalid in any
case that the product is taken apart or serviced by an unauthorized service station.
Send your package postage prepaid with a copy of your proof of purchase. You will also need to enclose a letter explaining
the nature of your difficulty in detail. Please allow 2-4 weeks for return shipping.
Smartek USA Inc. • 49 Bartlett Street Brooklyn, NY 11206 • 1-877-678-6232
Sunbeam™ logo is a trademark of Sunbeam Products, Inc. used under license.
Page 12

1 YEAR LIMITED WARRANTY

material and workmanship.
Insert the needle correctly
Polish with fine sand paper
Remove the spool of thread
from the spool pin, wind any
loose thread around it, and
rethread the machine
Adjust thread tension dial
according to the instructions
listed in "Adjusting Tension"
Remove and insert a new
needle
Insert a new needle and
tighten the screw of the
presser foot
Remove and insert a new
needle, and guide fabric
along gently
Remove and insert a new
needle turn hand wheel to
lower the needle into fabric,
and then start sewing
Sewing Machine Instructions