to the right, clicking it into
place. (Figure 5)
5.
Select a speed switch. This
will start the bobbin winding.
(Figure 6)
6.
When you have your desired amount of thread
on the bobbin, switch to OFF and move the
bobbin to the left (Figure 7) snip the thread.
(Figure 8)
Note:
It is preferable to manually assist in the
winding of the bobbin. Use your hands to guide the thread.
Threading the machine
Make sure that the power switch is on OFF.
1.
Place a spool of thread on the Spool Pin with
the thread end facing rear. (Figure 9)
2.
Clamp the reel cover over the Spool Pin so
that the thread remains in place. (Figure 10)
3.
Loop the thread around the outside of thread
guide 1. (Figure 11)
4.
Guide the thread into Groove 2, and pull
toward the chrome take-up
lever. (Figure 12)
5.
Feed the thread through the
hole in the chrome take-up
lever and pull straight down
to the needle. (Figure 13)
Sewing Machine Instructions
Figure 6
Figure 11
Figure 7
Figure 8
Figure 9
Figure 10
Figure 12
Page 5