Advertisement
Pass thread over top of tension control, do not wrap completely around
tension control (Figure 11).
Use the threader to pass the thread through the needle eye from back to
the front.
Loosen the bobbin nut and take off the bobbin. Slide thread spool onto
extension spindle. Connect the extension spindle on bobbin shaft (Figure
12).
Loosen the set screw with a screwdriver and take off the old needle and
insert a new one.
Needle must be installed with a flat side of the needle shank facing the
front of handheld sewing machine.
Always use a # 14 style DHx1 sewing needle.
The Handheld Sewing Machine is warranted for 1 year from provable date of purchase against defects
in material and workmanship. During this period such defects will be repaired, or the product will be
replaced without charge. This warranty does not cover damage caused by misuse, negligence or
improper installation. Warranty is also invalid in any case that the product is taken apart or serviced
by an unauthorized service station. Send your package postage prepaid with a copy of your proof of
purchase. You will also need to enclose a letter explaining the nature of your difficulty in detail. Please
Smartek USA Inc. • 49 Bartlett Street Brooklyn, NY 11206 • 1-877-678-6232
Sunbeam™ logo is a trademark of Sunbeam Products, Inc. used under license.
Instructions Manual
To Use a Standard Thread Spool:
Replacing the Needle:
1 YEAR LIMITED WARRANTY
allow 2-4 weeks for return shipping.
Page 4
Advertisement
