SATO CX Series Service Manual page 39

3-4 Chassis, Including the Front Case Removal/Replacement
The chassis must be removed to access and remove other components that are fastened to the
chassis body. The front case is set in slots in the bottom case and both are removed from the
chassis as a unit. The chassis is held in the printer case by two tabs, which can reached
through two access slots in the bottom of the printer. To simplify the process of removing the
chassis from the printer, follow these instructions closely.
REFER TO THE ACCOMPANYING ILLUSTRATIONS
To remove the chassis:
Insert a flat-bladed screwdriver into each of the two chassis release slots between
the tabs and case and push the screwdriver in the direction shown. .or the right
side slot, insert the screwdriver and push toward the front of the printer. .or the
left side slot, insert the screwdriver and push toward the rear of the printer
while pulling the chassis away from the printer case. The front case will come
out with the chassis. Lift the front case from the chassis.
INSERT SCREWDRIVER
INTO EACH SLOT, PUSH
UP ON THE RIGHT SIDE,
PUSH DOWN ON THE
PUSH DOWN
TO THE REAR
38
Rev B
All manuals and user guides at all-guides.com
LEFT SIDE
SATO SERVICE MANUAL
PUSH UP TO
THE FRONT
LEFT
SIDE TAB
CX Series Printers
CASE
TAB
INSERT SCREWDRIVER
BETWEEN TAB AND CASE
RIGHT
SIDE TAB