Table of Contents
Advertisement
1-7 Printer Test and Calibration
Calibrate Printer (Continued)
Continue to respond to the prompts or enter a choice on the sequential screens.
Sequence of events when the Calibration Program is run:
1.
The Indicator goes out.
2.
The motor slowly feeds a label until a gap or mark is found.
3.
The indicator glows green and prints one label with the message
"calibration successful".
4.
If the label does not print and the indicator glows red, repeat the
calibration procedure.
24
Rev B
All manuals and user guides at all-guides.com
SATO SERVICE MANUAL
CX Series Printers
Advertisement
Table of Contents
