8
8
7
7
4
3
5
6
1
1
Loop Handle without Barrier Bar
:
Place the clamp (3) in the loop
handle (4) and position them both
against the drive tube (5).
:
Fit the clamp (6) and line up the
holes.
:
Fit washers (7) on screws (8) and
insert screws in holes. Screw on the
square nuts (1) as far as stop.
:
Go to "Securing the Loop Handle".
KM 90, KM 90 R
A
9
10
Securing the Loop Handle
:
Secure the loop handle (4) approx.
8 in (20 cm) (A) forward of the
control handle (9).
:
Line up the loop handle.
:
Tighten down the screws firmly –
lock the nuts if necessaey.
:
The sleeve (10) is country-specific
and must be located between the
loop handle and control handle.
4-MIX Engine
The STIHL 4-MIX engine features
gasoil lubrication and must be run on a
fuel mixture of gasoline and engine oil.
It operates otherwise on the 4-stroke
principle.
4
English
15