Stihl FS 410 C K Instruction Manual page 13

9
10
Use the spring (9) from the parts kit
N
supplied with the machine.
Place the spring (9) in the lower
N
clamp molding (10).
A
1
2
Position the clamp moldings (1) with
N
handlebar (2) on the handle
support (11).
FS 410 C K
2
Raise the grip of the wing screw (7)
N
to the upright position.
Turn the wing screw
N
counterclockwise as far as stop.
Push the wing screw into the handle
N
support as far as stop and then
screw it down – but do not finally
tighten yet.
Adjust the handlebar (2) so that
N
distance A is no more than 15 cm.
Line up the handlebar at a right
N
angle to the drive tube.
11
Turn the wing screw clockwise as
N
far as stop.
7
N
Adjusting the handlebar
Opening the wing screw
N
N
Fold the grip of the wing screw down
so that it is flush.
Raise the grip of the wing screw to
the upright position.
Turn the wing screw
counterclockwise until the handle
support can be moved.
English
11