Battery Installation And Charging - AT&T DL72119 Quick Start Manual

Getting started

Battery installation and charging

Once you have installed the battery, the screen indicates the battery status
(see the following table). For best performance, keep the handset in the
telephone base or charger when not in use. The battery is fully charged after
16 hours of continuous charging. See the table in the Technical specifications
section on page 109 for battery operating times.
Battery indicators
The screen is blank or
shows Put in charger
and flashes.
The screen shows
Low battery and
flashes.
The screen shows
HANDSET X.
1. Plug the battery connector securely into the socket inside the handset
battery compartment. Insert the supplied battery with the label
THIS SIDE UP facing up, as indicated.
Battery status
The battery has no or very
little charge. The handset
cannot be used.
Battery has enough
charge to be used for a
short time.
Battery is charged.
Charge without interruption (at least
30 minutes).
Charge without interruption (at least
30 minutes).
To keep the battery charged, place it in the
telephone base or charger when not in use.
8
Action