Advertisement
D
HOW12ACM #2 Initial Hardware Setup
Repeat Steps 1-3 on the Basic Setup Guide of the HOW12ACM. In this Building to Building/Point to Point Setup,
we will configure HOW12ACM#2 as a Repeater.
E
HOW12ACM #2 Repeater Setup
a. To scan for your Wi-Fi signal, click
"Scan". If you only wish to scan in
2.4G or 5G, choose accordingly.
Clicking scan will scan for all
available Wi-Fi networks in the area.
c. After you select your network, it will
ask you to create a profile. You can
change the extended SSID if you
wish. By default it will use the same
SSID as your wireless source. The
security settings will also be listed
and it will automatically choose the
security settings of the wireless
source. Type in your password in the
"Key Field". This password will be
the same Wi-Fi password you used
for HOW12ACM #1
Click "Connect" and the device will now reset and save your settings. The basic settings for repeater mode are now configured!
F
HOW12ACM #2 Hardware Installation
Connect the HOW12ACM #1 to your POE injector/switch.
This will provide power to HOW12ACM #2. It does not need to
wired to the LAN side.
Point-to-Point mode is now complete. Mount the devices outside within view of each other and it should create a long range wifi
network that can reach up to 500ft+ and connect both locations together. Perfect for remote Wi-Fi security cameras, remote Wi-Fi
access, Outdoor Wi-Fi Hotspots, etc. Set up this long range outdoor Wi-Fi at a RV park, marina, backyards, warehouses, offices
and more. The HOW12ACM is durable and can withstand any outdoor condtions, including rain and snow.
Technical Support
© 2019 Hawking Technologies, Inc. All rights reserved. All trademarks herin are the property of their respective owners. Apple, Mac, iPad, and iPhone are registered trademarks of Apple Computer, Inc. No Affiliation implied or expressed.
LAN1 - PD-IN
AC Power
PoE
LAN
Tel: 1.888.202.3344
b. After it has finished scanning, a list
of networks will appear. Please
select the Wi-Fi Name you gave
HOW12ACM #1. You can select
either the 2.4GHz OR 5GHz Wi-Fi
name. It can only repeat from one
source. However, it will broadcast
this source in both the 2.4GHz and
5GHz range.
d. Enter the IP address settings you
wish to use for your access point.
You can use a dynamic (DHCP) or
static IP address, depending on your
network environment. This IP
address MUST be differnet from
HOW12ACM #1. Go back to the
previous section and click "Connect"
E-mail: techsupport@hawkingtech.com
HOW12ACM # 2
LAN1 - PD-IN
Ethernet cable for power
AC Power
PoE
LAN
Advertisement
