Hawking HOW12ACM Quick Installation Manual

Requirements
• Wired Network Connection
• A Wired Network Device (Mac or Windows
Computer)
• PoE Injector/PoE Switch (Not Included)
Package Contents
• 1x HOW12ACM
• 1x Ethernet Cable
• 1x Wall/Pole Mount Kit
• 1x Setup CD-ROM
• 2x Antennas
Start Here 
Initial Hardware Setup
1
Connect a PoE injector/switch into LAN1 PD-IN Port on the
HOW12ACM.
Connect a computer into the LAN port on the PoE injec-
tor/switch.
2 Computer Configuration
Configure the HOW12ACM with a Mac computer
a. Connect your computer to the
network using an ethernet cable. If
your computer is Wi-Fi enabled,
you'll need to turn off the Wi-Fi
connection from your computer until
you are done configuring the
HOW12ACM.
b. Open your System Preferences and
select the "Network" option.
c. Select the "Ethernet" option. Find the
"Configure IPv4" drop down menu
and select "Manually".
In the IP address, enter
"192.168.1.10".
In the Subnet Mask, enter
"255.255.255.0"
Select "Apply".
3 Accessing the Setup via Web Browser
a. Open any web browser from the computer that is plugged into
the HOW12ACM. In the address field, type in "192.168.1.230".
Press "Enter".
b. A security prompt will appear asking for a username/password.
Username: admin
Password: 1234
HOW12ACM
Product Description
LAN1 - PD-IN
AC Power
PoE LAN
HawkTech
WLAN
Q
Outdoor Wireless-AC1300 Managed Access Point/Extender
Antenna Ports
2x SMA Female Ports for Omnidirectional
Dual Band Antennas
LAN 2 Port (PSE)
IEEE 802.3af PoE PSE-Out
Reset Switch
Use a pin or similar small
object. Press and hold for
30 seconds to factory
reset device
LED Behavior
5G: 5GHz Wireless is enabled/disabled
2.4G: 2.4GHz Wireless is enabled/disabled
LAN2(PSE): LAN2 port is connected
LAN1(PD): LAN1 port is connected
Status: ON, Booting up process; OFF, No error
Power: On/Off
Configure the HOW12ACM with a Windows computer
a. Connect your computer to the network using an ethernet cable. If your
computer is Wi-Fi enabled, you'll need to turn off the Wi-Fi connection
from your computer until you are done configuring the HOW12ACM.
b. Go to your control panel and
select "Network and Sharing
Center" On the left hand column,
choose "Change Adapter
Settings" Right click on
"Ethernet" and choose
"Properties".
c. Select "Internet Protocol
(TCP/IPv4)" and click on
"Properties".
d. Select "Use the following IP
address". In the IP address, enter
"192.168.1.10". In the Subnet
Mask, enter "255.255.255.0" and
click "OK". Select "OK" again to
close the properties and save.
c. A window should appear asking what mode you wish to use. Select your
mode and click "Next".
Access Point: Go to Section 4a.
Wireless Repeater (Range Extender): Go to Section 4b
Bridge Client: Refer to Manual located on CD.
I
uick nstallation
LAN 1 Port (PD)
IEEE 802.3at PoE PD-In
Grounding Terminal
G
uide