Start Here
Start
Here
i
This Quick Installation Guide provides a quick
and easy way to set up the HOD45B in Access
Point, Bridge or Universal Repeater mode. If you
need to use the other modes, please refer to the
manual located on the CD.
1
Hardware Setup
1) Plug the provided antennas into the
HOD45B. One antenna will be connected to
an L-Shaped antenna connector. Screw the 2
antennas onto the bottom panel of the
HOD45B.
2) Installing the Waterproof Gasket.
Using a network cable, please attach the
waterproof gasket in the following order.
HOD45B
Package Contents
Connect the Ethernet
cable first into the
Ethernet/Power port on
the HOD45B. Then
tighten the bottom cap
on the Waterproof Gasket
to secure.
TM
TM
Hi-Gain
Hi-Gain
Outdoor Dual-Band Wireless-N Access Point/Bridge
Outdoor Dual-Band Wireless-N Access Point/Bridge
• 1x Outdoor Dual-Band Wireless-N
Access Point/Bridge
• 2x 5dBi Hi-Gain Dual-Band Dipole
Antennas
• 1x L-Shaped Antenna Connector
• 1x Power-Over-Ethernet (PoE) Adapter
• 1x Power Cable and Power Transformer
• 1x Waterproof Gasket
• 1x Three foot Ethernet Cable
• 1x Setup CD-ROM
• 1x Quick Installation Guide (QIG)
3) Installing the Power-over-Ethernet (PoE) Adapter
Plug the other end of the Ethernet Cable into the PoE Adapter. It should
go into the port labeled "Power + Data Out". Connect the power adapter
and power transformer to the PoE Adapter and into an available AC
Socket.
Note: An outdoor Ethernet cable is not included with the HOD45B and
must be purchased serperately. The maximum recommended length if 150
Feet for the Ethernet Cable.
Q Q
I
uick
uick
nstallation
nstallation
Requirements
• Ethernet Cable is required (length
will depending on mounting
location)
• Wired or Wireless Internet
Connection
• A Wired or Wireless Network Device
(Tablet, Smartphone, Mac or
Windows Computer
• Power Outlet
Reset Button
Reset to manufacturer settings - Unscrew
cover and use a long, thin object to press
for a minimum of 15 seconds, unplug the
power for a few seconds then plug it in
Ethernet/Power Port
Connects to PoE
adapter for power and
for wired connections
Antenna Connectors
Two RP N-Jack Antenna Connectors
Optional: If you wish to connect to
O
the HOD45B using an Ethernet
th
cable from a computer, connect an
ca
Ethernet cable to the port labeled
Et
"LAN" and plug the other end into
"L
yo
your computer. Skip to Step 3.
G
uide
uide