Auto Cue; Cueing Using The Jog Dial; Cueing Using The Search Keys; Cueing Using The Numeric Keys - Tascam CD-302 Owner's Manual

2 Select (
CUE_P
numeric keys.
3 Press the key.
ENTER
4 Select the cue point mode.
5 Press the
key.
ENTER
If you select the key mode (
PLAY
sen as the cue mode value), the last playback point is
captured and used as the as the cue point.
If you select the CUE key mode (
sen as the cue mode value), the operation is a little
different. When the unit is paused, and searching is
done using the JOG dial or the
CUE key will flash. Pressing the
the current position as the cue point.
NOTE
S
You can also set the cue point using the memory function.
(see 4.10, "Memories")
The cue point cannot be updated during A-B LOOP
play.
3.3.2

Auto Cue

The auto cue function allows searching the track and
auto-locating to the point where the audio level first
goes above a set threshold level. When this point is
reached, the unit enters pause mode.
Select the threshold level can be selected from:
, , , , , and
OFF –72 –66 –60 –54
When the auto cue function is on, the
cator in the display lights.
1 Press the
PRESET key.
2 Select (
A_CUE
numeric keys.
3 Press the key.
ENTER
4 Select the threshold value to be used for the
auto cue function.
5 Press the
ENTER key.
3.3.3

Cueing using the JOG dial

You can directly cue to any point using the
by frame accuracy, while the unit is in pause mode.
You can select the resolution of the dial so that one
rotation of the dial is equivalent to either 9, 18, or 36
frames.
1 Press the key.
PRESET
) using the dial or
( is cho-
PLY)
( CUE) is cho-
SEARCH keys, the
CUE key will store
dB.
–35
AUTO CUE indi-
) using the dial or
JOG dial
3 • Basic operations—Loop play
2 Select (
JOG
keys.
3 Press the
ENTER
4 Select the value (frames per rotation).
5 Press the
ENTER
3.3.4

Cueing using the SEARCH keys

You can also cue to frame accuracy, using the
keys to locate the playback point while the
SEARCH
unit is in pause mode.
3.3.5

Cueing using the numeric keys

You can also cue to any point using the numeric
keys.
The keys are used to enter the following values in
order: track number, minutes, seconds and frames.
1 When you have entered the value, press the
key. The unit starts playback
PLAY/PAUSE
from the input point.
If all the values are not entered, the other values are
set to zero. For example, if you only enter the track
number, minutes and seconds, the frames field will
be set to 00 , which means that the playback will start
from the exact start of that second.
If you make an entry containing a mistake, the dis-
play blinks to show this.
Use the CLEAR key to clear and cancel entries con-
taining mistakes.
3.4

Loop play

3.4.1

Selecting the loop mode

3 loop modes are available, as shown on the display:
—the whole
ALL
—a single track is repeated
SINGLE
A-B —between two points
) using the dial or numeric
key.
key.
17
TASCAM CD-302