Bushnell Elite 1 Mile ARC CONX Manual page 27

TROUBLE SHOOTING TABLE
If unit does not turn on - LCD does not illuminate:
• Depress POWER button.
• Check and if necessary, replace battery.
If unit powers down (display goes blank when attempting to power the laser):
• The battery is either weak or low quality. Replace the battery with a good quality 3 -volt lithium battery (CR123).
If target range cannot be obtained:
• Make sure Display is illuminated.
• Make sure that the power button is being depressed.
• Make sure that nothing, such as your hand or finger, is blocking the objective lenses (lenses closest to the target) that
emit and receive the laser pulses.
• Make sure unit is held steady while depressing power button.
• Make sure target is within minimum and maximum distances listed in the specifications. Environmental conditions
may have a negative impace on the maximum range (see "Ranging Accuracy", pg. 5).
NOTE: The last range reading does not need to be cleared before ranging another target. Simply aim at the new target using
the display reticle, depress the power button and hold until new range reading is displayed.
Warning: This product uses a Lithium based battery. Lithium batteries can overheat and cause
damage if physically abused. Do not use batteries that are damaged or show signs of physical wear.
27