Table of Contents
Advertisement
Status Tab
The Status tab contains the status and configuration of the controller, firmware and data connections.
GENERATOR MONITORING
Generator information is displayed on both the Generator operator screen and Generator tab within the maintenance
screens. For more information, refer to
ENGINE MONITORING
Engine information is displayed on both the Engine operator screen and Engine tab within the maintenance screens.
For more information, see
DIESEL EXHAUST FILTER MONITORING
This unit is equipped with a Diesel Particulate Filter (DPF) to meet current EPA emissions standards. This section
gives an explanation of the indicators that are displayed on the DPF Status page of the Engine tab.
To access the DPF Status page, press any direction arrow (▲, ►, ▼, ◄) to enter the maintenance screens, and
then while on the Engine tab, press the ▼ button to toggle through the pages until the DPF Status page appears.
There are four areas on the DPF Status page that communicate various information to the operator. The areas and
the indicators that appear in those areas are explained here:
•
HEST Lamp (High Exhaust System Temperature): This area will display the Regeneration Underway
indicator above the words "HEST Lamp - Solid" when the unit is in the process of diesel exhaust filter
regeneration. During the regeneration process, the exhaust temperature will be very high.
•
DPF Lamp: This area will display the Regeneration indicator above the words "DPF Lamp - Solid" when
auto exhaust filter cleaning is enabled. When the unit is being operated with auto exhaust filter cleaning
33722 D
SITE
Return Delay
GEN
Model
Application
USB ID
Bootloader
Ethernet
+ -
V
Link Quality
- CTS
- RTS
- DTR
- DSR
- DCD
Engine
Generator
1/1
Figure 2-18. Status Tab Screen
Operator Screens
Operator Screens
and
DPF Status
HEST Lamp - Solid
DPF Inhib
Engine
6/6
Generator
Figure 2-19. Regeneration Underway Indicator
MMG130DI4/175DI4/205DI4 Operating Manual
GENSET
480V/277V 3-Phase
10:00:00
Total
0.0
kW
0.0
0.0
kVA
Hz
0.0
kVAr
0.0
kW
%
0.00
kVAr
0.0
pf
%
Model
Bootloader
Application
Analogue
USB ID
Engine:
Supervisor State:
Engine State:
Load State:
Protections:
Logging
Total mem
100%
Log Dest:
Log mem free
Log Mode:
Log Time:
USB drive:
Host IP:
Slave IP:
Host Port:
Slave Port:
Alarms
Schedule
I/O
and
Maintenance
Maintenance
Screens.
DPF Lamp
Alarm
Alarms
Schedule
Status
I/O
00409
General Information
7741 \ 7740
07:10
Generator
0.0
kWh+
0.0
kVAh
0.0
kVArh
Status
00408
Screens.
21
Advertisement
Table of Contents
