TANDBERG Gatekeeper/Border Controller API D14172.01 User Manual page 45

Zones TraversalZone [1..50] Match [1..5] Pattern Type:
<Prefix/Suffix/Regex>
(Applies only if the Match mode is Pattern Match.) Determines the way in which the string
must match the alias. Prefix: the string must appear at the beginning of the alias. Suffix: the
string must appear at the end of the alias. Regex: the string will be treated as a regular
expression.
Zones TraversalZone [1..50] Match [1..5] Pattern Behavior:
<Strip/Leave/Replace>
(Applies only if the Match mode is Pattern Match.) Determines whether the matched part of
the alias should be modified before an LRQ is sent to this zone. Leave: the alias will be
unmodified. Strip: the matching prefix or suffix will be removed from the alias. Replace: the
matching part of the alias will be substituted with the text in the Replace string.
Zones TraversalZone [1..50] Match [1..5] Pattern Replace: <S: 0, 60>
(Applies only if the Pattern Behavior is Replace.) Specifies the string to be used as a
substitution for the part of the alias that matched the pattern.
SubZones DefaultSubZone Bandwidth Total Mode: <None/Limited/Unlimited>
Determines whether the Default Subzone has a limit on the total bandwidth being used by its
endpoints at any one time. None corresponds to no bandwidth available.
SubZones DefaultSubZone Bandwidth Total Limit: <1..100000000>
Sets the total bandwidth limit (in kbps) of the Default Subzone (applies only if Mode is set to
Limited).
SubZones DefaultSubZone Bandwidth PerCall Inter Mode:
<None/Limited/Unlimited>
Determines whether there is a limit on the bandwidth for any one call to or from an endpoint
in the Default Subzone.
SubZones DefaultSubZone Bandwidth PerCall Inter Limit: <1..100000000>
Specifies the bandwidth limit (in kbps) for any one call to or from an endpoint in the Default
Subzone (applies only if Mode is set to Limited).
SubZones DefaultSubZone Bandwidth PerCall Intra Mode:
<None/Limited/Unlimited>
Determines whether there is a limit on the bandwidth for any one call between two endpoints
within the Default Subzone.
SubZones DefaultSubZone Bandwidth PerCall Intra Limit: <1..100000000>
Specifies the bandwidth limit (in kbps) for any one call between two endpoints within the
Default Subzone (applies only if Mode is set to Limited).
SubZones TraversalSubZone Bandwidth Total Mode: <None/Limited/Unlimited>
Determines whether or not there is a limit to the total bandwidth of all traversal calls being
handled by the system.
SubZones TraversalSubZone Bandwidth Total Limit: <1..100000000>
Specifies the total bandwidth (in kbps) allowed for all traversal calls being handled by the
system (applies only if Mode is set to Limited).
D14172.01
TANDBERG Gatekeeper/Border Controller API User Guide
page 45 of 84