Using The Access Point Setup Wizard With Mobile - Cisco WAP581 Administration Manual

Using the Access Point Setup Wizard with Mobile

Uncheck Password Complexity to disable the password security rules. However, we strongly recommend
Note
keeping the password security rules enabled. For more information about passwords, see
39.
Step 13 Click Next. The Configure Radio 1 - Name Your Wireless Network window appears.
Step 14
Enter a Network Name. This name serves as the SSID for the default wireless network.
Step 15 Click Next. The Configure Radio 1 - Secure Your Wireless Network window appears.
Step 16
Choose a security encryption type and enter a security key. For a description of these options, see
Settings, on page
Step 17
Click Next. The Configure Radio 1 - Assign the VLAN ID for your Wireless Network window appears.
Step 18 Choose the VLAN ID for traffic received on the wireless network.
We recommend that you assign a different VLAN ID from the default (1) to the wireless traffic, in order to segregate
it from the management traffic on VLAN 1.
Step 19
Click Next. Repeat the step 13 to step 18 to configure the settings for Radio 2 interface.
Step 20 Click Next. The Enable Captive Portal - Create Your Guest Network window appears.
Step 21
Select whether or not to set up an authentication method for guests on your network, and click Next.
If you click No, skip to Step 29.
If you click Yes, the Enable Captive Portal - Name Your Guest Network window appears.
Step 22 Specify a Guest Network Name.
Step 23
Click Next. The Enable Captive Portal - Secure Your Guest Network window appears.
Step 24 Choose a security encryption type for the guest network and enter a security key. For a description of these options,
see Configuring Security Settings, on page
Step 25 Click Next. The Enable Captive Portal - Assign the VLAN ID window appears.
Step 26 Specify a VLAN ID for the guest network. The guest network VLAN ID should be different from the management
VLAN ID.
Step 27 Click Next. The Enable Captive Portal - Enable Redirect URL window appears.
Step 28
Check Enable Redirect URL and enter a fully qualified domain name (FQDN) or IP address in the Redirect URL
field (including https://). If specified, the guest network users are redirected to the specified URL after authenticating.
Step 29
Click Next. The Summary - Confirm Your Settings window appears.
Step 30 Review the settings that you configured. Click Back to reconfigure one or more settings. If you click Cancel, all settings
are returned to the previous or default values.
Step 31 If they are correct, click Submit. Your setup settings are saved and a confirmation window appears.
Step 32
Click Finish.
The WAP device was configured successfully. You are required to log in again with the new password.
Using the Access Point Setup Wizard with Mobile
The first time that you log into the Access Point with your portable device or after it has been reset to the
factory default setting, the Access Point Setup Wizard with mobile style appears. This helps you perform the
initial configurations. To configure the Access Point using the wizard, complete the following steps:
Cisco WAP581 Wireless-AC/N Dual Radio Access Point with 2.5GbE LAN Administration Guide
4
53.
53.
Getting Started
Security, on page
Configuring Security