Guest Group Table - Cisco WAP581 Administration Manual

Access Control
• Key-1 — Enter the shared secret key that the WAP device uses to authenticate to the primary RADIUS
server. You can use up to 63 standard alphanumeric and special characters. The key is case sensitive and
must match the key configured on the RADIUS server. For example, the secret can be 6n8!5ETGb^nd if
you use Purple Wi-Fi. The text that you enter is shown as asterisks.
• Key-2 — Enter the RADIUS key associated with the configured backup RADIUS servers. The server at
Server IP Address-1 uses Key-1, Server IP Address-2 uses Key-2.
For the Purple WiFi, the Server IP Address-1 and Address-2 varies for different regions. The table below
specifies the same:
Regions
AMERICAS
EUROPE
ASIA-PACIFIC
The value for Key-1 and Key-2 is 6n8!5ETGb^nd
• RADIUS Accounting — Check Enable to track and measure the resources that a particular user has
consumed, such as the system time and the amount of data transmitted and received.
If you enable RADIUS accounting, it is enabled for the primary RADIUS server and the backup server.
• Guest Group — If the Authentication Method is set to Local Database or Radius Authenticated, select a Guest
Group that was created previously . All users who belong to the group are permitted to access the network through
this portal.
• Redirect URL — To enable the URL Redirect, enter the URL (including http://). The range is from 0 to 256
characters.
• Session Timeout (min.) — Enter the time remaining, in minutes, for the CP session to be valid. After the time
reaches zero, the client is de-authenticated. The range is from 0 to 1440 minutes. The default value is 0. The session
timeout got from the Radius Server will over ride the user configured timeout in the event of a session timeout.
• Web Portal Locale — Select a web portal locale that was created previously from the drop-down list.
Step 4 Click Apply . Your changes are saved to the Startup Configuration.
Note Redirect URL and Web Portal Locale are not of use in EXCAP mode.
Please refer to Hardware manual in Purple Wi-Fi for more detailed settings of EXCAP

Guest Group Table

On the device, each local user is assigned to a user group and the group is assigned to a CP instance. The
group facilitates managing the assignment of users to CP instances.
The user group named Default is built-in and cannot be deleted.
To configure a local user:
Address-1
34.94.146.135
35.230.139.41
35.244.93.31
Cisco WAP581 Wireless-AC/N Dual Radio Access Point with 2.5GbE LAN Administration Guide
Guest Group Table
Address-2
34.94.183.201
35.246.18.82
35.244.98.247
99