General Requirements, Warnings And Limitations - Honeywell Miller RACDTA-5K6/6FT User Instruction Manual

Thank You
Thank you for your purchase of Miller fall protection equipment manufactured by Honeywell
Safety Products. Miller brand products are produced to meet the highest standards of quality at
our ISO 9001 certifi ed facility. Miller equipment will provide you with years of use when cared for
properly.
All persons using this equipment must read, understand and follow
all instructions. Failure to do so may result in serious injury or death.
Do not use this equipment unless you are properly trained.
Questions?
It is crucial that the authorized person/user of this equipment read and understand these instruc-
tions. In addition, federal law requires employers to ensure that all users are trained in the
proper installation, use, inspection, and maintenance of fall protection equipment. Fall protection
training should be an integral part of a comprehensive safety program.
Proper use of fall arrest systems can save lives and reduce the potential of serious injuries from
a fall. The user must be aware that forces experienced during the arrest of a fall or prolonged
suspension may cause bodily injury. Consult a physician if there is any question about the
user's ability to use this product. Pregnant women and minor children must not use this product.
1.0 General Requirements,
Warnings and Limitations
All warnings and instructions shall be
provided to authorized persons/users.
All authorized persons/users must reference
the regulations governing occupational
safety, as well as applicable ANSI or
CSA standards. Please refer to product
labeling for information on specifi c OSHA
regulations, and ANSI and CSA standards
met by product.
Proper precautions should always be taken
to remove any obstructions, debris, material,
or other recognized hazards from the work
area that could cause injuries or interfere with
the operation of the system.
All equipment must be inspected before
each use according to the manufacturer's
instructions.
All equipment should be inspected by a
qualifi ed person on a regular basis.
To minimize the potential for accidental
disengagement, a competent person must
ensure system compatibility.
Us er Ins tru ct ion s - Engl is h
WARNING
CALL
1.800.873.5242
3
Equipment must not be altered in any
way. Repairs must be performed only by
the manufacturer, or persons or entities
authorized in writing by the manufacturer.
Any product exhibiting deformities, unusual
wear, or deterioration must be immediately
discarded.
Any equipment subject to a fall must be
removed from service.
The authorized person/user shall have
a rescue plan and the means at hand to
implement it when using this equipment.
Never use fall protection equipment for
purposes other than those for which it was
designed. Fall protection equipment should
never be used for towing or hoisting.
Equipment must not be exposed to
environmental hazards and chemicals which
may produce a harmful effect.
Use in a corrosive or caustic environment
dictates a more frequent inspection and
servicing program to ensure the integrity of
the product is maintained.