Charging The Battery (Wlan Models Only) - Symbol SPS 3000 Series Programmer's Manual

To insert the iPAQ and SPS 3000 into the cradle:
1. Insert the iPAQ into the SPS 3000 (see
2. Align the connectors on the bottom of the iPAQ with the cradle's plastic pin and pin-
out connectors (see
3. Slide the iPAQ and SPS 3000 into the cradle as pictured below.
4. The iPAQ and SPS 3000 are connected to the cradle when they are seated firmly
in the cradle and the connectors are fully engaged.
iPAQ Connectors
Plastic Pin Connector
Pin-out Connectors
Figure 2-3. Inserting the iPAQ and SPS 3000 into the Cradle

Charging the Battery (WLAN models only)

Both the iPAQ and SPS 3000 include non user-accessible rechargeable Lithium-ion
batteries.The SPS 3000 battery powers the internal radio. Although the SPS 3000 ships
from the factory with a partially charged battery, it is recommended that you fully charge the
battery before using the SPS 3000.
Figure 2-3).
Figure 2-1).
Hardware Setup
2-3