Printek VehiclePro 420 Operator's Manual page 16

Some hosts require an extra connect step after pairing. After connecting, the printer will
issue an IP address to the host and the host can communicate to the printer as if it were a Wi-Fi
printer. The printer's address to the host is always
In the host device's browser (if equipped) this address may be entered in the address bar to
access the printer web page.
WI-FI Config:
Wireless Configuration
This will display the current Wi-Fi configuration:
IP Address – user defined. If Static Address Method is selected, type in the address the printer
will use on the network.
SubNetMask – user defined. If Static Address Method is selected, type in the subnet mark of the
network.
Gateway – user defined. If Static Address Method is selected, type in the gateway address of
the network.
SSID – user defined. Network name broadcasted by printer when set to Access Point mode.
Passphase – user defined. Password used to access the printer in Access Point mode
WiFi Port – user defined. Type in the IP port to be used by the printer. (default value = 8023)
Address Method – user selectable
Static – printer will always connect to the network using the IP address defined.
13 www.printek.com | P: 800.368.4636 | F: 269.925.8539 | E:
169.254.200.1.
info@printek.com