Advertisement
SYSTEM
CONFIGURATION
QUICK SETUP
IMPORTANT:
ACCESSING THE
ON SCREEN DISPLAY
Speaker Setup Screen
-SPEAKER SETUP-
FRONT
YES
CENTER
YES
SURROUND
2
BACK
YES
SUB
CRSOVR
5.1 SURR
6
STEP 1
Connect the S–1000 to your system, using Table 1 on page 4 as a guide. You are
ready to configure the S–1000 through the interactive on-screen menus in the setup
menu. For best performance, configure the loudspeakers before playing music.
Please note:
On Screen Display (OSD). The S–1000 has three OSD outputs: component,
S-video, and composite. There is no OSD available from the HDMI
To View the Setup Menu. Connect any of the OSD outputs on the S–1000 to
the appropriate input on your video display. Press the remote control menu
key. The front panel display reads
simultaneously. Tune the video display input to match the selected OSD video
connection.
STEP 2
Enter the setup menu. The
STEP 3
Select
LISTENING ROOM SETUP
screen appears.
SETUP
STEP 4
Select
SPEAKER SETUP
screen appears.
SETUP
S–1000
FULL RANGE
FULL RANGE
FULL RANGE
FULL RANGE
NORMAL
80 Hz
SURROUND
FULL RANGE
Full Range sends 20Hz to 20KHz signals to the loudspeaker. Limited sends infor-
mation from the crossover frequency (see below) to 20KHz to the loudspeaker. The
frequencies below the crossover frequency are sent to the subwoofer if present;
otherwise, these low frequencies are sent to the full range loudspeakers in the sys-
tem.
SUB
Select
or
NORMAL
subwoofer.
sends the low frequencies from the limited speakers and the .1 (or
– NORMAL
LFE) signal to the subwoofer.
–
ENHANCED
speakers to the subwoofer in addition to the low frequencies from the limited
loudspeakers and the .1 (or LFE) signal.
MENU MODE
screen appears on the video display.
MAIN MENU
from the
MAIN MENU
from the
LISTENING ROOM SETUP
Using this screen, you can activate loudspeakers that
are in your system in the left column and select loud-
speaker characteristics in the far right column.
Scroll through the available options and select your
loudspeaker setup.
For a 5.1 system, select
For a 6.1 system, select 1 back speaker.
For a 7.1 system, select 2 back speakers.
Note
When 1 back speaker is selected, the signal is present at the
left back output.
to choose the amount of bass information sent to the
ENHANCED
sends additional bass information from the left and right loud
output.
TM
and all OSD outputs activate
screen. The
LISTENING ROOM
screen. The
SPEAKER
back speakers.
NO
Krell S–1000
Advertisement
