Table of Contents
Advertisement
Rear Panel (Connecting Your Equipment)
To prevent malfunction and equipment failure, always turn down the volume, and turn off all the units before making any connections.
1
MIC IN 1, 2 connector
Connect your microphone here.
* Pin assignment of MIC IN connectors
2
INPUT (CH 1–CH 4) jacks
These jacks input sound to channels 1–4. The CH 1 and C H2 INPUT
jacks support phono input from MM-type cartridges.
Set the input select switch of the mixer section appropriately for the
device you're connecting.
3
PHONO GROUND terminal
If a turntable (analog) is connected to the CH 1 or CH 2 INPUT jacks,
connect the turntable's ground terminal here. This suppresses noise
from the turntable.
* Unsuitable places for connection
5 Water pipes (may result in shock or electrocution)
5 Gas pipes (may result in fire or explosion)
5 Telephone-line ground or lightning rod (may be dangerous in the
event of lightning)
4
MASTER OUT (L, R) connectors
Connect your powered speakers or power amp here.
Both XLR type and RCA phono type plugs are supported.
* Pin assignment of MASTER OUT connector (XLR type)
5
BOOTH OUT (L, R) jacks
These are the output jacks for booth monitoring.
* Pin assignment of BOOTH OUT jacks
6
ZONE OUT (L, R) jacks
Use these output jacks when you want to send signals to another
location independently from MASTER OUT or BOOTH OUT.
Connect them to your speakers or recorder.
7
MIDI OUT connector
This outputs MIDI messages such as MIDI clock.
8
PC A, B port
Use the included USB cable to connect this port to your computer.
To connect this to your computer, you must install the USB driver.
&"Installing the Software" (p. 3)
9
[POWER] switch
This turns the power on/off.
NOTE
When turning off the power, follow the directions that appear in the
display.
* The power to this unit will be turned off automatically after a
predetermined amount of time has passed since it was last used for
playing music, or its buttons or controls were operated (Auto Off
function).
If you do not want the power to be turned off automatically,
disengage the Auto Off function.
For details on how to disable this function, refer to the owner's manual
(PDF).
NOTE
5 Any settings that you are in the process of editing will be lost when
the power is turned off. If you have any settings that you want to keep,
you should save them beforehand.
5 To restore power, turn the power on again.
10
DC IN jack
Connect the included AC adaptor here.
* Use the cord hook to secure the cord of the AC adaptor as shown in
the illustration.
Panel Descriptions
Power cord
Indicator
AC Outlet
9
Advertisement
Table of Contents
