Eccentric screws
The eccentric screws
the fit of the base plate
♦
Tighten the eccentric screws
play between the circular saw and the guide
rails
.
Sawing (without guide rail)
Right-angled sawing
♦
Hold the machine with both hands firmly on the
handles
and
.
♦
Switch on the appliance as described in
"Switching on and off" .
♦
Place the appliance with the front part of the
base plate
on the workpiece .
♦
Swivel the motor down and saw forwards with
moderate pressure – never backwards .
Mitre angles up to 45°
♦
Adjust the cutting angle as described .
♦
Hold the machine with both hands firmly on the
handles
and
.
♦
Switch on the appliance as described in
"Switching on and off" . Place the appliance
with the front part of the base plate
workpiece .
♦
Swivel the motor down and saw forwards with
moderate pressure – never backwards .
Plunge cuts
♦
When making a "plunge cut" which is not at
right angles, secure the base plate of the saw to
prevent any lateral movement . Lateral movement
can cause the saw blade to jam, thus causing
a kickback .
♦
Adjust the desired cutting depth as described
above .
♦
Place the appliance on the workpiece .
♦
Avoid kickback and place the rear edge
against a stop (as referenced in the section
"Plunge cutting with guide rail") .
♦
Switch on the appliance as described in
"Switching on and off" .
PTSS 1200 C1
are intended for adjusting
on the guide rail
.
to reduce the
on the
♦
Hold the machine with both hands firmly on the
handles
and
NOTE
►
The cut width marking
blade guard shows the front and rear cutting
point of a 165 mm at maximum cutting
depth . This applies both to plunge cuts with
guide rail
and plunge cuts without guide
rail
.
Sawing (with guide rail)
Right-angled sawing with guide rail
♦
Place the guide rail
element on the workpiece .
♦
Place the appliance with the groove
guide rail
.
♦
Switch on the appliance as described in
"Switching on and off" .
♦
Hold the machine with both hands firmly on the
handles
and
Mitre angles up to 45°
♦
Apply the guide rail
element onto the workpiece .
♦
Place the appliance with the groove
guide rail
.
♦
Adjust the cutting angle as described .
♦
Hold the machine with both hands firmly on the
handles
and
.
♦
Switch on the appliance as described in
"Switching on and off" . Place the appliance
with the front part of the base plate
workpiece .
♦
Swivel the motor down and saw forwards with
moderate pressure – never backwards .
and pivot it .
on the side of the
with the foam rubber
onto the
and pivot it .
with the foam rubber
onto the
on the
GB │ IE │ NI
│
9
■