Startup - Hach TitraLab AT1000 Series Basic User Manual

Startup

Chemical exposure hazard. Obey laboratory safety procedures and wear all of the personal protective
equipment appropriate to the chemicals that are handled. Refer to the current safety data sheets
(MSDS/SDS) for safety protocols.
Personal injury hazard. Never use the instrument without the syringe cover installed.
Configure the instrument
1. From the main menu, select Settings.
2. Select an option, then push Select.
Option
Applications
Operators
Date + Time
Brightness
Sounds
Language
Network
Legacy settings
Info
Restore Defaults Sets the instrument to the default configuration.
Options
Security
3. Push Back.
Install the applications
Use the supplied USB key to install the applications. The instrument can install a maximum of five
applications for each syringe installed. For two syringes, the installed applications shown on the top
line of the display refer to syringe one and the installed applications shown on the second line refer to
syringe two.
1. Push Home to go to the main menu.
2. Connect the USB key to the USB port on the side of the instrument. The applications on the USB
key show on the display.
3. Push the arrow keys to highlight and select an application to install. Push the left or right arrow
key to select it. Do this step again to select additional applications to install.
18 English
Description
Changes, makes copies, exports and removes application data. Make sure that the
duplication function does not make more than five applications for each syringe installed.
Adds, changes and removes operators.
Sets the instrument date and time.
Sets the brightness of the display.
Sets the sound options.
Sets the language.
Give a name to the instrument. This name is used to connect the instrument to a PC. If a
printer is connected, this name is printed on the hard-copy output. Restart the instrument
if the name is changed.
Specify the sensor data when the legacy adapter is used.
Shows information about the instrument and the attached hardware.
Sets the application parameters view to expert mode. When the instrument is set to off,
sets the syringe to empty into the titrant bottle. Changes the temperature display unit.
Prints the measurement and derivative curves if a printer is connected. Specify if a
balance is connected. Specify if a propeller stirrer is connected.
Change the password and specify which options are password protected.
C A U T I O N
C A U T I O N