One-Touch Timer Recording - Sylvania DVR90DG Owner's Manual

Video
VR
DVD-RW DVD-RW DVD-RW DVD-RW
This is a simple way to set the
recording time in blocks of 30
minutes. Check that the disc you
are recording onto has enough
space for the time you set.
When the recording finishes the
recorder automatically goes into
standby.
1
Turn on the unit and load a
recordable disc.
Make sure that the TV input is set
on the unit.
This operation may take a
while to be recognized.
2
Using [REC SPEED], select a
recording speed.
Refer to "Recording speed" on
page 24.
3
Using [CH K / L] or the Number
buttons, select a desired chan-
nel to record.
Recording

One-touch Timer Recording

4
DVD-R DVD-R
Press [REC/OTR] repeatedly to
select desired recording time.
Recording times appear on the TV
screen (30 minutes to 8 hours).
Recording will start.
I 0:30
(Normal Recording)
8:00
When the unit reaches the
specified time, it will be turned off
automatically.
To change the recording length
during the One-touch Timer
Recording, press [REC/OTR]
repeatedly until the desired length
appear.
To cancel the One-touch Timer
Recording within the specified
time, press [STOP C] .
This operation may take a
while to be completed.
0:30
1:00
7:30
POWER OPEN/CLOSE
TIMER
ZOOM PROG.
A
.@/: ABC DEF
3
1 2 3
GHI JKL MNO CH
4 5 6
PQRS TUV WXYZ REPEAT
7 8 9
DISPLAY SPACE CLEAR SETUP
0
T OP MENU MENU/LIST RETURN ENTER
K
{ B
L
2
REC SPEED REV PL AY
FWD
h B g
SKIP PAUSE SKIP
Bx1.3/0.8
H F G
4
REC/OTR STOP CM SKIP
C
Note
• The remaining recording
time will appear on the
display panel during a One-
touch Timer Recording.
Press [DISPLAY] to see it
on the TV screen.
• You cannot pause a One-
touch Timer Recording.
• Unlike a Timer Recording,
you can perform the following
operations during a One-touch
Timer Recording.
-Turning the power off
-Using [REC/OTR] and
[STOP C]
• The unit will be turned off
automatically under the
following conditions.
1)No space remained on the
disc
2)When a power failure occurs
4
29