Table of Contents
Advertisement
INSTALLATION
- The picture may differ from the actual product.
- Consult a professional installer prior to mounting the TV using a wall bracket.
1
How to Attach the Brackets for the Product to the TV
- If the screw will not fully tighten when using a guide spacer, recheck the assembly depth of the screw and refer to the technical service
manual.
Guide spacer
2
How to attach to masonry walls
Please follow the below direction.
- Check the material of the wall and the thickness of the finishing.
- Use the appropriate anchor for a concrete wall, and install them in a manner. That does not crack the wall.
- Do not mount the device on the walls made from wood stud, plasterboard or medium density fiberboard (MDF). In this case, the
anchor and screws must be inserted into the concrete behind the finish surface. If there is no concrete on the other side, then you
must first install a separate hanger to securely install the anchors and screws.
- When installing the product on wall material not designated, install the product so that each location can withstand the pull out load of
70 kgf (686 N) and shear load of 100 kgf (980 N) or above.
a
d
- Use the Ø 8 mm drill bit for concrete and hammer (Impact) drill.
a. Use a drill bit Ø 8 mm to drill a hole for the anchor location within a depth of 80 mm - 100 mm.
b. Clean the drilled hole.
c. Insert the sealed anchor to the hole. (When inserting the anchor, use a hammer.)
d. Set the wall mount on the wall by aligning to the location of the hole. and, set the angle adjusting part to face upward.
e. Align the wall mount bolt to the hole and tighten it. Then, fasten the bolts at torque of 45 kgf/cm - 60 kgf/cm.
4
Guide spacer screw
b
Wall mount screw
e
- Work procedure
1. Check to see if the display has screws installed into
the mounting holes. If so, remove those.
2. Assemble the guide spacer and the guide spacer
screw in order as shown in the picture.
- Place the TV on a table with the screen facing
down. Make sure that you place it on a flat
surface covered with a soft cloth or cushion to
protect it from scratches.
- Secure the guide spacers to the TV with the
screws.Assemble the guide spacer to the set by
tightening the screw.Tighten the screw until the
set, guide spacer and the screw are fully pressing
against one another.
- Use the + driver (manual or motorized) when
tightening the screw.
c
Anchor
Advertisement
Table of Contents
