Electrolux EB6SL70KCN User Manual page 49

The steam cleaning functions support the
steam cavity cleaning of the oven.
Before you start a cleaning
procedure, make sure that
the oven is cool.
When the steam cleaning function works,
the light is off.
1. Fill the water drawer to the maximum
level.
2. Choose the steam cleaning function
in the menu: Cleaning.
Steam Cleaning - the duration of the
function is around 30 minutes.
a) Turn on the function.
b) When the programme ends a
signal sounds.
c) Press the rotary knob to turn off
the signal.
Steam Cleaning Plus - the duration
of the function is around 75 minutes.
a) Spray a suitable detergent
uniformly in the oven cavity on
both enamel and steel parts.
b) Turn on the function.
After around 50 minutes a signal
sounds. The first part of the
programme ends.
c) Wipe the cavity of the oven with
a non-abrasive surface care
sponge. You can use warm water
or oven detergents.
d) The final part of the procedure
starts. The duration of this stage
is around 25 minutes.
3. Wipe the cavity of the oven with a
non-abrasive sponge. You can use
warm water.
4. Remove the remaining water from
the water drawer.
After cleaning keep the oven door open
for approximately 1 hour. Wait until the
oven is dry. To speed up the drying you
can heat up the oven with hot air at
temperature 150 °C for approximately 15
minutes. You can get maximum effects of
the cleaning function if you manually
clean the oven immediately after the
function ends.
11.5 Cleaning Reminder
When reminder is displayed cleaning is
necessary. Perform the function Steam
Cleaning Plus.
11.6 Cleaning the water drawer
Remove the water drawer from the
appliance.
1. Remove the lid of the water drawer.
Lift the cover in correspondence with
the protrusion in the rear.
M
A
X
2. Remove the wave-breaker. Pull it
away from the drawer body until it
snaps out.
3. Wash the water drawer parts with
your hands. Use tap water and soap.
Do not use abrasive
sponges. Do not put
water drawer inside a
dish washer.
After you clean the water drawer parts,
reassemble the water drawer.
1. Snap in the wave-breaker. Push it
into the drawer body.
2. Assemble the lid. First insert the front
snap and then push it against the
drawer body.
M
A
X
M
A
X
3. Insert the water drawer inside the
appliance.
4. Push the water drawer towards the
oven until it latches.
ENGLISH 49