Advertisement
D
The Camera mode will
Push the SNAP button
HINT: The Down arrow toggles between camera/video
to record an image or
start a video recording
F
1. In the menu highlight Setup
and press the OK button
6. Highlight Motion Detect Interval and
press OK to choose 1, 3 or 5. The
number indicates the pause in seconds
between two instances of motion detection
Swann Communications • Toll Free Technical Support: USA - 1-800-627-2799, 1-877-274-3695, Australia - 1300 13 8324 • Email: tech@swann.com.au
RedAlert / BlueAlert DVR Easy Setup Guide
Manual Recording
The Video mode will
will take approximately
take a still image
10 seconds of video
mode when viewing your cameras
2. Choose Motion Detect Area
and press the OK button
7. Next highlight Motion Detect
Sensitivity and press the OK
button
E
Press the MODE
button to enter
Date image
playback mode
recorded
Use the LEFT and
RIGHT arrows to
Time image
change images
recorded
3. Use the Left and Right arrows
4. Next use the arrows to move the
to change the size of area to
rectangle to a region you want to
detect and press the OK button
detect and hit the OK button
8. Within the rectangle is where
9. Finally, back in the main menu
motion will be detected. The
change Capture Format to Photo
lower the Target Value the
or AVI. Note the Interval and Count
easier to sense/begin recording
options apply only to photo detection
Viewing Recorded Images
Type of capture
photo or video
Image number
Motion Detection Recording Setup
5. Hightlight Motion Detect Count and
press OK to change between 1, 3 or 5.
The number indicates how many
images will be captured per detection
10. To activate motion detection, set
Motion Detect to ON in the menu
or when viewing your camera push
the UP arrow to toggle motion on/off
www.swannsecurity.com
Advertisement
