Heat & Glo LOGS-SL550TRS-D Log Placement Instructions page 2

LOG NOTCHES
STEP 4.
LOG #3 (SRV2065-703) Place log #3 on right side of
grate. The notch on the log should fi t over the bar on the
far right side of the grate. Push the right side of log #3
against the grate tab and pull the left side forward until
it comes into contact wiht the burner detail as shown in
Figure 1.
STEP 5.
LOG #4 (SRV2065-704) Place log #4 so that the notch
is touching the fi rst grate tine and is laying in the fl at spot
of log #2. The right end of log #4 should touch the back
refractory panel. See Figure 2.
STEP 6.
LOG #5 (SRV2065-705) Place log #5 on log #2. The
front left of the log will rest on log #4. Log 5 must be
pushed back against refractory. See Figure 3.
Heat & Glo • SL-550TRS-IPI-D • 2065-935 Rev. E • 9/06
1 1
LOG/BURNER DETAIL CONTACT AREA
Figure 1.
LOG TOUCHES REFRACTORY PANEL
4 4
1 1
NOTCH
Figure 2.
LOG #5/REFRACTORY PANEL CONTACT POINTS
5 5
4 4
1 1
Figure 3.
2 2
3 3
3 3
2 2
2 2
3 3