Heat & Glo LOGS-6000GLX Log Placement Instructions

Log Set Assembly: LOGS-6000GLX
Model: 6000GLX-IPI
If the gas logs have been factory installed they
should not need to be positioned. If the logs have
been packaged separately, refer to the following
instructions.
STEP 1.
CAUTION: Logs are fragile! Carefully remove
the logs, grate and supporting cardboard from
the inside of the fi replace See Figure 1.
STEP 2.
Place the metal grate on top of the burner.
Position the legs of the grate into the forward set
of indentations in the burner top. See Figure 2.
STEP 3.
Log #1 NG (SRV2101-085):
Log #1 LP (SRV2101-087):
Log #1 is the left burning log. The air shutter in
the end of the burner tube goes over the left brass
orifi ce located behind the main burner. The left
end of the log goes tight against the left refractory
wall. See Figures 3 and 4.
1 1
Figure 3 Front View
LOGS-6000GLXLP
Figure 1
Figure 2
Heat & Glo • 6000GLX-IPI • 2101-910 Rev. C • 8/06
5 5
1 1
7 7
3 3
HUMP HUMP
1 1
Figure 4 Top View
LOG PLACEMENT
INSTRUCTIONS
4 4
2 2
6 6
1