Advertisement
Quick Links
Log Set Assembly: LOGS-SL550TRS-D
Model: SL-550TRS-IPI-D
STEP 1.
CAUTION: Logs are fragile!
Carefully remove the logs from the packaging.
STEP 2.
LOG #1 (SRV2065-701) Place log #1 on left fl at side of
the burner assembly. Pull the log and slide it to the right
until the notches under the log are in the burner grooves.
STEP 3.
LOG #2 (SRV2065-702) Place log #2 on the grate bar
and push it back against the refractory. The pilot should
be centered within the large notch on log #2.
LOG NOTCHES
Heat & Glo • SL-550TRS-IPI-D • 2065-935 Rev. E • 9/06
LOG PLACEMENT
INSTRUCTIONS
3 3
1 2 2
1
1
1
2 2
1 1
4 4
5 5
Advertisement
Related Manuals for Heat & Glo LOGS-SL550TRS-D
Summary of Contents for Heat & Glo LOGS-SL550TRS-D
- Page 1 Log Set Assembly: LOGS-SL550TRS-D LOG PLACEMENT Model: SL-550TRS-IPI-D INSTRUCTIONS STEP 1. CAUTION: Logs are fragile! Carefully remove the logs from the packaging. 1 2 2 LOG NOTCHES STEP 2. LOG #1 (SRV2065-701) Place log #1 on left fl at side of the burner assembly.
- Page 2 LOG NOTCHES LOG/BURNER DETAIL CONTACT AREA STEP 4. LOG #3 (SRV2065-703) Place log #3 on right side of grate. The notch on the log should fi t over the bar on the Figure 1. far right side of the grate. Push the right side of log #3 against the grate tab and pull the left side forward until it comes into contact wiht the burner detail as shown in Figure 1.