Table of Contents
Advertisement
Figure 6-3. Removing the Front Bezel
Accessing the Drive Bays
SCSI Drives: Because of their hotswap capability, you do not need to ac-
cess the inside of the chassis or power down the system to install or
replace SCSI drives. Proceed to the next step for instructions.
CD-ROM/Floppy Disk Drives: For installing/removing a CD-ROM or floppy disk
drive, you will need to gain access to the inside of the 6014H-8/6014H-82/
6014H-X8 by removing the top cover of the chassis. Proceed to the "CD-
ROM and Floppy Drive Installation" section later in this chapter for instruc-
tions.
Note: Only a "slim" CD-ROM drive and a "slim" floppy drive will fit into the
6014H-8/6014H-82/6014H-X8.
Removing the Top Chassis Cover
First, release the retention screws that secure the server unit to the rack.
Grasp the two handles on either side and pull the unit straight out until it
locks (you will hear a "click"). Next, depress the two buttons on the top of
the chassis to release the top cover and at the same time, push the cover
away from you until it stops.
chassis to gain full access to the inside of the server.
Chapter 6: Advanced Chassis Setup
1. Unlock
2. Press release knob
3. Remove bezel assembly
You can then lift the top cover from the
6-5
Advertisement
Table of Contents
