Table of Contents
Advertisement
S
S
UPER
ERVER 6014H-8/6014H-82/6014H-X8 Manual
Figure 6-1.
Slim-Line CD-ROM Drive
Power Supply
Mouse/Keyboard
Upper Screw
Lower Screw
6-2
Control Panel
The control panel (located on the front of the chassis) must be connected
to the JF2 connector on the serverboard to provide you with system status
indications. A ribbon cable has bundled these wires together to simplify the
connection. Connect the cable from JF2 on the serverboard to the appro-
priate header on the Control Panel PCB (printed circuit board). Make sure
the red wire plugs into pin 1 on both connectors. Pull all excess cabling out
of the airflow path.
The control panel LEDs inform you of system status.
System Interface" for details on the LEDs and the control panel buttons.
Details on JF2 can be found in "Chapter 5: Advanced Serverboard Setup."
Chassis: Front and Rear Views
Floppy Drive
SCSI Drives
USB0/1
COM1 Port
Ethernet Ports
Low-Profile Release Tab (see page 5-9)
System LEDs
System Reset
PCI Expansion Slots
VGA Port
6-2
Control Panel
Main Power
External SCSI Port
See "Chapter 3:
Advertisement
Table of Contents
