Led Descriptions - Multitech Conduit MTCDT-L4E1 Hardware Manual

SPECIFICATIONS

LED Descriptions

Label Name
PWR Power
STATUS Power Status
LS Link Status
A-B-C-D --
CD Carrier Detect
Signal Signal Strength
If a cellular radio is installed, the typical LS (Link Status) LED behavior is the following:
OFF - No power to the cellular radio
Continuously Lit - Not registered
Slow Blink (-0.2Hz) - Registered or connected
On the back of the Conduit, the RJ-45 Ethernet LEDs (located at the bottom of the connector) are defined as
follows:
Orange LED (lower-left) indicated activity/link. Blinks when there is transmit and receive on the
Ethernet link. It shows a steady light when there is a valid Ethernet connection.
Green LED (lower-right) indicates link speed. Lit when Ethernet is linked at 100Mbps. If not lit, Ethernet
is linked at 10 Mbps.
12
Conduit mLinux Model Front Panel
Conduit Application Model Front Panel
Description
Solid (constant) green if unit is on indicating that DC power is present.
Default condition: LED blinks when mLinux is fully loaded.
Varies with radio model.
These 4 LEDs are user-specified. Present on the Conduit mLinux model only.
This LED is on when a cellular data connection is made. Present on the
Conduit Application model only.
These 3 LEDs display the strength of the cellular signal. Present on the
Conduit Application model only.
Conduit
®
Cat 4 for EU/UK MTCDT-L4E1 Hardware Guide