Plustek MobileOffice D28 User Manual page 13

a. Select "Locate and install driver software (recommended)" when the "Found
New Hardware" window is displayed.
b. Click on the [Continue] button when the "User Account Control" dialog pops up.
c. Insert the Setup/Application CD-ROM, included with your scanner, into your
CD-ROM drive when the system prompts you "Insert the disc that came with
your USB Scanner＂， and click on the [Next] button.
d. During the process of the installation, a message "Windows can't verify the
publisher of this driver software" might be prompted. Please ignore it, and
click on [Install this driver software anyway] to continue the installation without
any misgiving at your scanner functioning.
5. When the system completes the installation, click on the "Finish" button.
6. Follow the on-screen instructions to install all software that your new USB scanner
requires.
7. After the software is installed, close all open applications and click on the "Finish"
button to restart your computer.
8. After the computer is restarted, you will be prompted to perform the scanner
calibration.
9. Insert the special calibration sheet, included with the scanner, face up into the page
feed of the scanner.
10 . Follow the on-screen instructions to complete the scanner calibration.
11. After the calibration, the DigiDoc window will be pop-up for you to configure the
LED function tab. If you never click any LED function tab, the LED indicator will
show "0", and the Simplex/Duplex button is useless.
Attention
If the scanner installation is not started and displayed
automatically on the screen, click "START", select "Run" and type
in "D:\Install" (where D: is the drive letter assigned to the CD-
ROM drive of your computer.)
Alternatively you may also use any plain white sheet of paper
sized in A4 (210 by 297 mm) instead; however, the calibration
effect may be less good than the special calibration sheet.
9