Alcatel-Lucent 1677 SONET Link Manual page 208

DLP-125
Disconnect BITS-0 source (J501) below shelf. See figure 125-1.
273
Are errors reported?
274
Refer to 1677 SONET Link Maintenance and Trouble Clearing manual
275
(PN 3EM13853AF) to determine source of error before going to next step.
Reset test set error count to zero and monitor for 10 seconds.
276
Are errors reported?
277
Reseat standby TC unseated in step
278
Enter
279
Enter
280
Observe output. Note states of disks in CCC in slot 10.
281
Is state of disks in CCC in slot 10 OOS-MA?
282
Enter
283
secondary.
Enter
284
secondary.
Did output return COMPLD or DENY?
285
Enter
286
Observe output. Note states of disks in CCC in slot 10.
287
4-164
If yes, go to step 275.
If no, record information in CKL-115, then go to step 277.
If yes, go to step 275.
If no, record information in CKL-115, go to step 278.
to restore TC.
RST-EQPT::TC-11-B;
to check state of disks.
RTRV-DISK;
If yes, go to step 283.
If no, go to step 333.
ACT-DISK::DISK-A10::::MODE=SEC,ACTION=ACTIVATE;
ACT-DISK::DISK-B10::::MODE=SEC,ACTION=ACTIVATE;
If COMPLD, go to step 286.
If DENY, go to step 333.
RTRV-DISK;
265 in slot 11B.
Verify Clock and Control Subsystem Switching
3EM13850AD
Issue 01, September 2007
to activate disk A10 as
to activate disk B10 as