To Prevent The Outdoor Unit From Falling Over; Starting Up The Outdoor Unit - Daikin Altherma 3 H HT Installation Manual

7 Starting up the outdoor unit

5 Attach the grille to the unit.
6.4 To prevent the outdoor unit from
falling over
In case the unit is installed in places where strong wind can tilt the
unit, take following measure:
1 Prepare 2 cables as indicated in the following illustration (field
supply).
2 Place the 2 cables over the outdoor unit.
3 Insert a rubber sheet between the cables and the outdoor unit
to prevent the cables from scratching the paint (field supply).
4 Attach the ends of the cables and tighten them.
NOTICE
Discharge grille. Do NOT use too much force to prevent
damage to the discharge grille.
Installation manual
16
7 Starting up the outdoor unit
See the indoor unit installation manual for configuration and
commissioning of the system.
WARNING
Rotating fan. Before powering ON or servicing the outdoor
unit, make sure that the discharge grille covers the fan as
protection against a rotating fan. See:
▪ "6.2 To install the discharge grille" on page 14
▪ "6.3 To remove the discharge grille, and put the grille in
safety position" on page 15
EPRA14~18DAV3+W1
Daikin Altherma 3 H HT
4P586100-1 – 2019.07