Network Settings Of The Unit - Panasonic AW-RP60G Operating Instructions Manual

Network settings of the unit

To control a remote camera connected via an IP connection from the
unit, you need to set the network settings of the unit.
Note
z Correct operation is not possible if the same IP address already
z
exists in the same network.
The message "IP Duplicate" may be displayed during start up,
etc., when duplicate IP addresses have been detected.
Set IP addresses that are not duplicates of any existing IP
addresses.
Setting the IP address of the unit
1.
Press the [MENU] button.
2.
Select the [RP IP SET] SYSTEM menu.
3.
Operate the menu operation dials to select the [IP] item
and then press to confirm.
AW-UE70
RP IP SET
NETWORK
SETTING
STATIC
IP
192 168
SUBNET
255 255
z This is set to [192.168.0.9] by default.
4.
Use the menu operation dials to set the IP address of
the unit to one that is not a duplicate of that of another
device.
Enter this in 4 blocks of numerals.
If [UPLOAD] in the first row is not executed, the changes are not
updated.
z The "IP Duplicate" message is displayed when the connection
destination IP address of the remote camera is duplicated, and it
cannot be registered.
Refer to the "Settable addresses" (page 28).
Notes
z In order for the setting to take effect, the unit must be
z
restarted. Turn off the unit's power, and then turn it back on.
z Consult the network administrator before setting the IP
z
address.
1/3
UPLOAD
(push)
0 9
255 0
27
Setting the subnet mask
1.
Press the [MENU] button.
2.
Select the [RP IP SET] SYSTEM menu.
3.
Operate the menu operation dials to select the
[SUBNET] item and then press to confirm.
AW-UE70
RP IP SET
NETWORK
SETTING
STATIC
IP
192 168
SUBNET
255 255
z This is set to [255.255.255.0] by default.
4.
Use the menu operation dials to set the subnet mask of
the unit.
Enter this in 4 blocks of numerals.
If [UPLOAD] in the first row is not executed, the changes are not
updated.
z "Unavailable Subnetmask setting" is displayed if a value that
cannot be set is entered.
Refer to the "Settable addresses" (page 28).
Note
z In order for the setting to take effect, the unit must be
z
restarted. Turn off the unit's power, and then turn it back on.
1/3
UPLOAD
(push)
0 9
255 0