Jacuzzi Arga Swirlpool Operating Instructions Manual page 6

Installation Instructions
3
Apply the grease included in the drain alignment kit to the end of the brass tailpiece. Carefully team lift the bathtub while
a third person removes and discards the material that was supporting the feet (Fig. 6). Carefully lower the tub in the same
position down into the drain alignment kit, using caution to avoid damage to the brass tailpiece.
4
Install your bathtub filler according to the manufacturer's directions included with the purchased filler, sold separately (Fig. 7).
5
Turn power supply on for GFCI protected outlet and ensure that the system performs properly (Fig. 8).
6
Clean up debris left over from the construction steps taken thus far. Place weights on the tub and allow the silicone to cure.
Now that installation is completed, use the last two pages of this manual to complete the warranty registration for this product.
Page 6
Fig. 6
Fig. 7
Fig. 8
www.jacuzzi.com
Arga™ Bathtubs
Installation Instructions