Table of Contents
Advertisement
Experience Arga™
Before Use
Close the drain and fill the bathtub until water is at least 1" to 2" (25 mm to 51 mm) above the highest jet (see water line
1
indicated in the illustration - Figure 1). Do not turn on the system at any time if the jets are not completely immersed in water.
Running the system when there is insufficient water in the bathtub could result in water spraying outside the bath area.
ATTENTION: When exiting the bathtub, the water level will drop below the jets which could result in water being sprayed
out of the unit. To prevent this, you must turn unit OFF before exiting bathtub.
Swirlpool™
2
To activate the Swirlpool™ function, touch the
NOTE: The Swirlpool™ function is programmed to run for 20 minutes, after which the function stops automatically. To stop the
function earlier if preferred, simply touch the
Salt Infuser & Jacuzzi® Epsom Salts
The Arga™ is specifically designed to allow for the use of Jacuzzi® Epsom Salts through the integrated salt infuser. The salt
infuser relieves the need to mix the salts by hand, perfectly blending the salts and delivering them into the bathing well through
the waterfall. Salt use is not required to operate the waterfall.
Salts can be added before or during the Swirlpool™ function, before starting the waterfall. To add, rotate the display toward
3
the inside of the tub as shown (Fig. 6). Check that the strainer basket is in the infuser, and pour 8-9 oz. (1 container) of Epsom
Salt inside before returning the control panel to closed position.
WARNING: Do not add salt without the strainer basket present. Do not use more than one container of salt at a time. The
use of more than one container of Epsom salt or salt use without the strainer basket could potentially clog the system.
Page 10
Fig. 4
button briefly (the function starts after lifting your finger) (Fig. 5).
Fig. 5
button again.
Fig. 6
www.jacuzzi.com
Arga™ Bathtubs
Operation Instructions
Hide quick links:
Advertisement
Table of Contents
