Drain Installation; After Installing The Finished Floor - Jacuzzi Arga Swirlpool Operating Instructions Manual

Arga™ Bathtubs
Installation Instructions

Drain Installation

Install the metal drain/waste fitting (supplied with the tub) into the
1
drain hole as illustrated (Fig. 2). Ensure that the drain opening on
the waste fitting is situated in the integral overflow channel. Use
the brass fitting SS99000 & relevant MZ20000 pieces as needed
by model (Fig. 3a/b).
A - For Arga™ Classic: Use SS87000 ABS adapter with poly
2
adapter, brass tailpiece and nut from the drain alignment kit
included in your tub. These will be used for the conversion (Fig.
3a).
B - For Arga™: Use SS99000 brass tailpiece with the threaded
tailpiece from the drain alignment kit and install directly to
SS99000 (Fig. 3b).
A - Cut the brass tailpiece to length. For SS87000 connection,
3
deburr and roll the cut edge with a swage tool. Install
components to the brass tailpiece as shown (Fig. 3a).
B - Cut the brass tailpiece to length. Install components to the
brass tailpiece as shown (Fig. 3b).
Glue the brass tailpiece assembly to the direct drain.
4

After Installing the Finished Floor

Place bathtub on supports (ex. blocks or 4x4 lumber), ensuring tub feet are fully supported (Fig. 4).
1
CAUTION: Bathtub comes factory pre-leveled, however it may be necessary to make adjustments to the levelling feet. These
feet operate in a manner similar to those of a home appliance. Prior to beginning installation, check to ensure that the tub is
level and make adjustments to the feet as needed.
Connect the electrical plug to the dedicated GFCI-protected outlet and confirm tailpiece sits properly over drain alignment kit
2
(Fig. 5). Apply silicone to the bottom of tub to attach to floor when lowered in step 3.
CAUTION: Ensure that the skirt has been fully bolted on before moving further.
Installation Instructions
Fig. 4
Fig. 5
www.jacuzzi.com
Fig. 3b
✓
Page 5